Honest limits
What it does not do
We publish this list on purpose. A clear no before you decide is better than a surprise afterwards.
Licences not sold yet
The free trial can be downloaded and the licence window is in the add-in, but no licence can be bought yet. The price will be published when sales open.
External spur gears only
Helical, internal, rack, bevel and worm gears are not supported.
No strength calculation
It does not calculate load capacity or rate a gear for a load. Sizing a gear for its duty is up to you.
Single gears, not pairs
It does not design gear pairs or trains, calculate a centre distance or split profile shift between two gears.
A part, not a drawing
It creates the part only. No technical drawing, gear data table, PDF or DXF, and no span or over-pins measurements.
Sharp-cornered tooth root
The tooth root has no fillet: the flank meets the root circle at a sharp corner. Where the root circle lies below the base circle, the flank runs down to it as a straight radial line. It is not the trochoid a generating tool cuts, and there is no protuberance or grinding allowance.
No bore or keyway
The part is a solid toothed disc, with no bore, hub, keyway or chamfer. Add them in SOLIDWORKS.
No stored parameters
Parameters are not saved with the part, and a generated gear cannot be reopened in the add-in. To change a gear, generate a new one.