Capabilities
What it does
Free trial
This page describes what the first public version of Gearing Expert does. It has been tested by the publisher in SOLIDWORKS 2022.
External spur gears
Involute spur gears with external teeth, one gear per part. Helical, internal, rack, bevel and worm gears are not in the current version.
One parameter window
All inputs are in one window, opened from the Gearing Expert tab on the SOLIDWORKS ribbon. Each box accepts only the range listed below.
Checks before the part is made
Undercut risk and a pointed tooth tip are reported in the window as soon as a value is entered. The generate button is disabled while any check fails.
Native SOLIDWORKS features
The gear is built from a sketch and an extrusion in a new part. There is no macro feature: the part opens without the add-in installed.
Volume read back
Once the part exists, the add-in reads its volume from SOLIDWORKS mass properties and shows it next to the value it expected.
Parameters and ranges
Input limits of the current version. A value inside the range can still fail a check, for example undercut risk with few teeth.
| Parameter | Range |
|---|---|
| Module m | 0.1 – 50 mm |
| Number of teeth z | 6 – 500 |
| Pressure angle α | 10° – 35° |
| Profile shift coefficient x | −1 – +1 |
| Face width b | 0.1 – 1000 mm |
Compared with SOLIDWORKS
What SOLIDWORKS already does, what we add, and what only this add-in does. Where SOLIDWORKS can do it too, we say so.
| Feature | Compared with SOLIDWORKS |
|---|---|
| Involute spur gear tooth | Goes beyond SOLIDWORKS SOLIDWORKS Toolbox has spur gears, but its help says they are representations for machine design, not true involute gears for manufacturing. Gearing Expert draws each flank as the involute calculated from your module, number of teeth, pressure angle and profile shift. Toolbox comes with SOLIDWORKS Professional and Premium and is not available in a 3DEXPERIENCE installation. Source: SOLIDWORKS 2027 · Professional |
| Undercut and pointed-tip checks | Only in this add-in The Toolbox gear topic in SOLIDWORKS help describes no tooth checks, and because those gears are not true involutes, undercut does not apply to them. Gearing Expert checks undercut risk and a pointed tooth tip as soon as you enter a value, and makes no part while a check fails. Source: SOLIDWORKS 2027 · Professional |
| Part made of native SOLIDWORKS features | Also in SOLIDWORKS Toolbox gears are ordinary SOLIDWORKS parts too. Gearing Expert keeps the same rule: a plain sketch and an extrusion with no macro feature, so the part opens and can be edited on a computer without the add-in. Source: SOLIDWORKS 2027 · Professional |
| Volume check of the generated part | Also in SOLIDWORKS SOLIDWORKS Mass Properties (Tools > Evaluate > Mass Properties) shows the volume of any part. Gearing Expert reads that value right after it creates the gear and shows it next to the volume it calculated, so you see at once that the geometry came out as intended. Source: SOLIDWORKS 2027 · Standard |